Webinar: ARM corelink, Arteris NoC, UCIe, Bunch-of-wires, CXL and PCIe

Sep 27, 2024  |  Author : admin_mirabilis

ARM corelink, Arteris NoC, UCIe, Bunch-of-wires, CXL and PCIe – Designing the interconnect is not for the weak-hearted! Timings:  Session 1: 11:30 AM India / 3:00 PM Japan or Korea / 2:00 PM China Register here: https://bit.ly/4elxVwY Session 2: 10:00 AM PDT / 1:00 PM EDT Register Here: https://bit.ly/4epEQ8v With so many Network-on-Chip (NoC) solutions […]

Read more


ARM vs RISC-V Cores | System level Comparison-Latency, Power

Aug 16, 2024  |  Author : admin_mirabilis

Methodology for System-level Comparison of ARM vs RISC-V Cores for Latency and Power Consumption System-level analysis is the only methodology to compare the performance and power consumption of two processor architectures. Unfortunately, processor models to perform the comparison are not easily available. This article describes a performance and power comparison methodology using system-level IP between […]

Read more


Reducing Power Consumption | Early System-Level Modeling

Aug 08, 2024  |  Author : admin_mirabilis

Measuring and Reducing Power Consumption Using Early System-Level Power Modeling Power evaluation in the early stages of the product design has been performed mostly using analytical methods such as spreadsheets. These spreadsheets typically contain the power for different tasks or devices and the sheet adds the worst case or the average of the power.  These […]

Read more


Power Management with Modeling and Simulation

Jul 04, 2024  |  Author : admin_mirabilis

Exploring Power Management with Modeling and Simulation using VisualSim Power management has often used the speed/power ratio metric (Mhz per Watt) as a measure of performance/power efficiency.  If one processor had a higher Mhz per Watt rating than another, then presumably it would be more power efficient.  Within a processor family, this may be true, but the […]

Read more


VisualSim – Power Solution

May 15, 2024  |  Author : admin_mirabilis

VisualSim – Power Solution VisualSim offers Power Solution starting from power generation to power distribution. There is also a support for Power Verification. The architects can make decisions such as allocation of power budget, selection or fine tuning the power management algorithms, sizing of power generators based on the observed results. Integration of Thermal Management […]

Read more